· Socalled vertical roller mills are shown here in more detail (Figure 1). The raw material falls over the chute (2) onto the center of the grinding table (3). The material to be ground moves to the edge of the grinding table under the effect of the centrifugal force and thus passes under the hydropneumatically springloaded grinding rollers (4).
· The service life of the bearing is greatly reduced. At the same time, it will be difficult to dismantle it from the grinding roller due to over tightening when the bearing is damaged, which will bring further difficulties to the vertical grinding mill. If it is too loose, the gap between the grinding tracks will increase, and the grinding roller the bearing cannot be closely connected.